Therefore, experimental study on impinging stream drying of wood particles bears important academic significance and practical value.
因此，开展刨花对撞流干燥的实验研究具有重要的学术意义和实用价值。
The important part of the thesis was the experimental study on the seismic capacity of the circular RC columns with wrapped CFRP sheets under high axial ratios.
论文的重点工作是对CFRP布横向包裹钢筋混凝土圆柱在高轴压比下的抗震性能进行了试验研究。
Theoretical and experimental study on the reliability of micro drill is carried out.
首次对微小钻头可靠性进行了理论和试验研究。
Objective To provide cells resource for experimental study on vascular tissue engineering.
目的为培养组织工程化血管的实验研究提供细胞来源。
An experimental study on the fatigue crack growth of GH4169 superalloy has been carried out.
本研究中对GH4169高温合金的疲劳裂纹扩展性能进行了试验研究。
The experimental study on the mixing chamber of pulse detonation engine prototype is performed.
对脉冲爆震发动机的混合室进行了实验研究。
An experimental study on the Nanometerization of non-crystallized alloys by means of applying d.
利用直流高压电场处理非晶态合金使之纳米化的研究。
Theoretical and experimental study on the polarization modes are performed on copper vapour lasers.
本文对铜蒸气激光的偏振模式进行了理论和实验研究。
The experimental study on Diesel Oxidation Catalyst was also conducted for particulate aftertreatment.
后处理方面主要是进行了氧化催化转换器的试验研究。
This paper presents an experimental study on acoustic agglomeration of coal-fired fly ash at low frequencies.
通过实验研究了低频下燃煤飞灰的声波团聚。
The theoretical analysis and experimental study on the air embolism phenomenon are carried out in this paper.
对气体栓塞现象做了比较深入的理论分析和初步的实验研究。
Objective experimental study on the inducing apoptosis and relative signal of human SPC-Al cells by Curcumin.
目的研究姜黄素对人肺癌细胞内凋亡相关信号的影响。
An experimental study on the control system of a clutch-to-clutch type automatic transmission is conducted on test bench.
在台架上对某一离合器到离合器式自动变速器的控制系统进行了试验研究。
This paper reports an experimental study on the dose, hardening effects, solution stability of photographic hardener H-18.
本文对乙烯砜基坚膜剂h—18在用量、坚膜效果、溶液的稳定性方面进行了试验。
This research possesses considerable value for the experimental study on rectangular case drawing as well as practical work.
该研究结果对非回转对称拉深的试验研究及实际生产具有一定的参考价值。
An experimental study on the polishing glossiness of granite surface has been conducted under different polishing conditions.
在实验的基础上，比较和分析了抛光条件对板面光泽度的影响。
In the present investigation, the experimental study on multiple - reverse thermal effect of composites has been carried out.
本文对几种复合材料的多级逆热效应进行了实验研究，并对实验结果进行了讨论。
The experimental study on an electron-beam-initiated hydrogen fluoride laser with SPG-200 pulsed power generator is introduced.
介绍了利用SPG-200脉冲功率源产生电子束激励氟化氢激光的实验研究情况。
Using generator fault simulation platform, an experimental study on low levels of deterioration of rotary rectifier was performed.
利用发电机故障模拟平台对旋转整流器早期故障进行了试验研究。
Then introduces an experimental study on the application of topic map technology in knowledge navigation for a dust devil archive.
接着，以沙尘暴研究领域的知识导航为例进行了主题图在数字化知识组织中的试验性应用研究。
An experimental study on distinguishing stability margin of two phase flow by means of system correlation identification is described.
进行了用相关分析系统辨识方法判别两相流稳定裕度的实验研究。
An experimental study on forced convection heat transfer of single-phase water in vertical and horizontal narrow annuli was performed.
对竖直及水平窄缝环形流道内单相水受迫对流换热进行了实验研究。
Presented in this paper are the results of experimental study on the magnetic-field-immersed foilless diode of a Raman free electron laser.
文章给出了用于一台喇曼自由电子激光器磁场浸没型无箔二极管工作特性的实验研究。
In this paper, experimental study on drying efficiency and energy consume of China firs wood bunch was performed in a circular hot-air dryer.
采用热风循环试验干燥机对杉木木束进行干燥速度与能耗试验，探讨杉木木束的干燥性能。
In this paper, an experimental study on spectra of vibration acceleration and frequency response functions of DG3-brush cutter was carried out.
该文对国产DG3型割灌机的振动频谱以及各振源点与手柄间的振动传递函数进行了实验分析。
This paper deals with some results of experimental study on semi-brittle behavior of rocks at the conditions relevant to the middle-lower crust.
本文着重介绍了在中下地壳温度、压力条件下进行的几种岩石半脆性蠕变的实验研究结果。
By applying SPC technology, the experimental study on processing performance of homemade YK2050 CNC spiral bevel gear grinding machine was done.
应用统计过程控制技术，对国产七轴五联动数控螺旋锥齿轮磨齿机yk2050的加工性能进行实验研究。
The paper presents an experimental study on the splitting strength and compressive strength of hybrid fiber reinforced high-performance concrete.
目的揭示钢纤维和聚丙烯纤维混杂后对高性能混凝土强度和抗裂性能的影响。
An experimental study on elastoplastic stability of single layer reticulated shells has been carried on in the laboratory to verify the analysis theory.
本文为了论证单层网壳结构弹塑性稳定分析的理论，进行了单层网壳结构的弹塑性稳定试验研究。
An experimental study on elastoplastic stability of single layer reticulated shells has been carried on in the laboratory to verify the analysis theory.
本文为了论证单层网壳结构弹塑性稳定分析的理论，进行了单层网壳结构的弹塑性稳定试验研究。
应用推荐