To see what's going on in main() we can set a breakpoint at a particular line or on a function in the program code so gdb will interrupt execution when it is reached.
为了查看在main()中发生了什么情况，可以在程序代码中的某一特定行或函数中设置断点，这样gdb会在遇到断点时中断执行。
Register the sequence number, interrupt nature, and thread attributes to the main program.
向主程序注册序号、中断属性和线程属性。
Data between X9241 and SCM is transmitted with I2C Bus, and the software includes main program and interrupt subprogram.
X9241采用二线串行i2c总线与单片机传递数据。其软件由主程序、中断子程序组成。
After analysis the function of system software, main program, interrupt service program and subroutine were designed use modeling develop ways.
分析了系统软件的功能，采用模块化软件设计方法，设计了控制系统主程序、中断服务程序以及子程序。
The software programs include main program, PWM interrupt program, PI control program of current and MRAC control program of speed.
软件设计主要包括主程序、PWM中断程序、电流PI调节程序、速度MRAC调节程序。
The software is divided into main program module, interrupt module, fault disposal module. These subroutines of each module are designed respectively.
设计了主程序模块、采样中断模块、故障处理模块，并分别编制了子程序。
Then, the whole systematic architecture, some hardwares and firmware program were detailed, finally, the main program and interrupt service program were provided.
洋细论述了系统的总体结构、部分硬件设计和相应固件程序的实现，给出了主程序和中断服务程序流程图。
The control program includes timing interrupt service program, external interrupt service program and main program.
控制程序设计包括定时中断服务程序、外中断服务程序及主程序。
The software for control system was designed according to the timing requirement, the main program and the interrupt service program were highlighted.
根据热丝tig焊的时序要求，设计了控制系统的软件，重点介绍了主程序和中断服务程序。
This paper describes the software main program circle and the major interrupt program.
并介绍了软件主程序和主要的中断程序。
The basic circuit diagram, the main program flow chart and the display interrupt flow chart of four Chinese characterses display module are also given.
给出了四汉字显示模块的硬件电路原理图、主程序流程图以及中断显示流程图。
The system softwares include main program, voltage zero interrupt program and other sub-program, The system is designed with the model block.
系统软件包括主程序，市电过零中断服务程序和多种子程序构成，采用模块化方法设计。
Software design is divided into two parts, the main program and interrupt service routine.
软件设计分为两块，主程序和中断子程序。
The system software includes the main program and interrupt service program.
系统软件主要由主程序和中断服务程序组成。
The system software includes the main program and interrupt service program.
系统软件主要由主程序和中断服务程序组成。
应用推荐