This paper presents a feasible scheme of the current detection system based on the magnetic balanced Hall current sensor.
本文提出一种基于磁场平衡式霍尔电流传感器的永磁直线同步电机的电流检测系统及其实现方案。
It analyzes the technique of extracting the spindle motor current of the Machining Center, correspondingly, points out that Hall current sensor is a very efficient way.
对自由曲面数控加工中主轴电机电流信号的提取技术进行了分析，指出了霍尔电流传感器是行之有效的方法。
The high-precision resolver was connected to PMSM with the same shaft to detect the position and speed of PMSM, and Hall current sensor was adopted to detect current of PMSM.
位置和速度的检测采用高精度的旋转变压器和电机同轴相连，电流的检测采用霍尔电流传感器，具有很高的检测精度。
The hardware is made up of Data Acquisition card (DAQ) and signal conditioning extension for instrumentation (SCXI) which is composed of Hall voltage current sensor.
系统的硬件平台主要由数据采集卡和霍尔电压电流传感器构成的信号调理器组成。
The current is sampled by Hall sensor and a current feedback control system is designed.
通过霍尔传感器进行电流采样，设计了电流反馈的控制系统。
Hall sensor is used to collect voltage and current signal, and the collected result displayed by LED displayer.
利用霍尔传感器完成电压、电流的采集，并送led显示器显示。
The converter uses a resistor to sense current signal instead of Hall sensor in addition.
另外，采用电阻替代霍尔传感器检测电流信号。
Electromagnetism isolated Hall sensor is used to sense the phase current of the PMSM, and the IGBT CPV363M4K module is used to implement the inverter.
采用电磁隔离霍尔元件进行电流检测，采用了IGBTCPV 363m 4 K模块组成逆变桥来实现功率主回路直流到交流的逆变。
A closed loop control system is formed by current and Voltage feedback system by means of HALL sensor and potentiometer.
借助输出电压采样和霍尔元件，设计了电流、电压反馈电路，形成了闭环控制系统。
While DC current transformer is questionable in locomotive application, the Hall-generator current sensor, on the other hand, appears to be advanced in performance.
文章概述了直流互感器在机车上应用所存在的问题及霍尔电流传感器的优越性能；
While DC current transformer is questionable in locomotive application, the Hall-generator current sensor, on the other hand, appears to be advanced in performance.
文章概述了直流互感器在机车上应用所存在的问题及霍尔电流传感器的优越性能；
应用推荐