A bridge limiter is a bridge circuit used as a limiter circuit.
桥式限幅器用桥式电路作为限幅电路。
This article puts forward a kind of strain gauge active bridge circuit.
本文提出了一种电阻应变片有源电桥电路。
The output characteristics of the bridge circuit which supplied with constant voltage source are analysed.
分析了恒压源供电下的桥路输出特性以及影响电桥电压灵敏度的各种因素。
The follow bridge circuit has cut off or high resistanced. The trouble is convergence coil, brush or amplifier.
随动电桥断路或高电阻出现，故障是汇电环、电刷、或放大器。
The results show that the control strategy make full-bridge circuit in the large signal perturbation stability.
结果表明该控制策略能够使全桥电路在大信号扰动下稳定工作。
In this paper, a new bridge circuit for cold junction compensation, in which extension wire is not needed, is proposed.
本文提出了一种新型的冷端温补桥路，使用该桥路时无需使用补偿导线。
Realization of High Precision Temperature Detection With Single-Armed Bridge Circuit By Software Compensation Technique;
针对“数据处理和控制装置”测温电路的高精度要求，提出了一种分档电桥电路的标定方法。
A method is introduced that reversible rectification can be realized with single-phase half-bridge circuit in this paper.
文中介绍了采用单相半桥电路实现可逆整流的方法。
The attenuation formulae of HF bridge circuit with phase-ground coupling and adjacent phase impact or not are derived in this paper.
本文导出了不考虑邻相影响和考虑相邻影响条件下的相地耦合高频桥路衰减公式。
Although single-armed bridge circuit is easy to construct, but is not suitable for high precision temperature detection because of its inner error.
单臂电桥测温电路结构简单，但存在误差而难以实现高精度温度检测。
Using the characteristic of integrated operational amplifier, an electric bridge circuit sensor without nonlinear error in its output voltage is designed.
利用集成运算放大器的特点，设计了输出电压无非线性误差的电桥电路传感器。
Based on the traditional bridge circuit, an active bridge circuit, which performs high sensitivity and good linearity, is designed for capacitance measurement.
在传统电桥电路的基础上，设计了一种有源电桥的电容式检测电路。该电路具有灵敏度高、线性范围宽的特点。
The platform is designed with TMS320F2812 as its core and realizes PWM signal trigger with EPM7128. The three-phase full-bridge circuit is constructed with IR2130.
平台以TMS320F2812为核心控制器，以EPM7128实现PWM信号触发，以IR2130为驱动芯片构建了三相全桥逆变电路。
The program PSPICE is used for simulating the bridge circuit of pressure sensor with the nonlinear resistor model to show properties of electric drift as well as thermal drift.
利用PSPICE程序结合非线性电阻模型来模拟压力传感器的电桥电路，可显示零点电漂移和热漂移特性。
In the plan of design, the fourth generation of IPM is used as the main half-bridge circuit and TMS320LF240X DSP with good performance and strong function is used as a controller.
在设计方案中，采用第四代IPM作半桥主电路，以性能好、功能强的数字信号处理器TMS320 LF 240 X DSP为控制器。
The two-arm bridge measuring low resistance circuit of MCU control, multivibrator measuring electric capacity, auxiliary leveling bridge circuit, output display circuit are designed.
设计了单片机控制双臂电桥测量低电阻电路、多谐振荡测量电容电路、辅助调平电桥电路、输出显示等电路。
The invention relates to a novel six-phase permanent magnet fault-tolerant motor control system in a half-bridge circuit structure, which has the characteristic of failure isolation.
一种新颖的具有故障隔离特性的半桥电路结构六相永磁容错电机控制系统。
The error includes two sides, one is the calculation error about Wheatstone bridge circuit, and another is the effect of the sharp pulse producing when test current is loaded on the sample.
系统误差分析分为两个方面，一是与惠斯顿电桥电路有关的计算误差；二是测试电流脉冲加载时出现的尖脉冲引起的误差。
A three phase half controlled bridge circuit with constant current and high efficiency is designed in the charged loop of the welding power supply. So a limiting current resistance is canceled.
在焊接电源的充电回路中设计了三相桥式半控、恒流高效充电回路，取消了限流电阻；
In order to meet the needs of high accuracy of temperature measurement for a data process and control device, a simple calibration method for the bridge circuit measuring resistances is proposed.
针对“数据处理和控制装置”测温电路的高精度 要求，提出了一种分档电桥电路的标定方法。该方法 不仅简单实用，在电桥分档位较多时，能有效减少标定 的工作量，而且能达到较高的精度。
The thermal resistance temperature sensor, the electric-bridge circuit, the single power supply op amp, the monolithic computer and the moving magnetic coil are electrically connected in sequence.
热电阻传感器、电桥电路、单电源运放、单片计算机、动磁线圈依次电连接；
The utility model relates to a high frequency radiation eliminating device for electronic transformer of neon lamps, which is composed of a bridge circuit which is composed of diodes and a capacitors.
霓虹灯电子变压器高频辐射消除装置由二极管组成桥式电路和电容组成。
In the light of circuit principles, the author has mathematically ascertained that the contact resistance in an integrated circuit has little effect on the accuracy of output signals from the bridge.
本文由电路原理和数学方法推导出集电装置的接电阻对电桥输出信号精度的影响非常小的结论。
The SPMC75F2413A chip is used as main control chip to control single-phase bridge inverter main circuit.
系统以SPMC75 F 2413 A作为主控芯片来控制单相桥式逆变主电路。
A practical interface Circuit for transducers based-on bridge measurement is described in this paper.
本文介绍了一种实用的用于电桥测量的传感器接口电路。
In the design, to produce circuit TL494 as a PWM output control signals, control of the on-switch situation, the half-bridge flyback output on the basis of the power of multi-output.
在设计中，以TL 494作为PWM产生电路输出控制信号，控制开关管的导通状况，在半桥反激式输出的基础上实现了电源的多路输出。
Full-Bridge converter is the main circuit topology of the inverter.
论文选取全桥变换器作为主电路拓扑。
The method of design high frequency transformer in half bridge inverter circuit is introduced exampled in detail, besides temperature rise and power loss are discussed.
依据一个半桥逆变电路的实例详细介绍了高频变压器设计的一般方法和步骤，并讨论变压器损耗和温升问题。
This paper analyzes that the characteristics of several forces such as surface tension, electromagnetic pinch, gravitation and viscosity etc. act on short circuit liquid bridge.
分析了短路液桥的重力、表面张力、电磁收缩力、气体爆破力、粘滞力的特点及其对短路过渡过程的影响。
To single phase SCR bridge rectification circuit of constant potential instrument, the expression of load voltage is derived and harmonic component of load voltage is analyzed in detail.
文中针对船用恒电位仪单相可控桥式整流电路，推导了负载电压表达式，分析了负载电压的谐波组成；
应用推荐