Larger contact Angle type has better axial load capability.
更大的接触角型具有较好的轴向负荷能力。
A direction can only carry axial load, can't bear radial load.
只能承受一个方向的轴向载荷，不能承受径向载荷。
This type of bearings is separable which can only carry axial load.
是可分离型轴承，只能承受轴向载荷。
This type of bearings is separable, which can only carry axial load.
推力球轴承是可分离型轴承，只能承受轴向载荷。
OBJECTIVE: To investigate the impact of axial load on lumbar dural sac.
目的：实验拟探讨轴向负荷对腰椎硬膜囊的影响。
When the shaft has axial load, it can be used in combination with other bearings.
当有轴向负荷时，应和其他轴承组合使用，它不限。
Adjusting roller bearings can bear the load and two radial direction of the axial load.
调心滚子轴承可以承受径向负荷及二个方向的轴向负荷。
The calculating formula for critical axial load of worn rod string and tubing was set up.
建立了铅垂油井杆管偏磨临界轴向压力的计算公式。
Four-point contact ball earings used for rolling mill roll the oil tank to withstand the axial load.
四点接触球轴承多用于轧钢机的油辊箱以承受轴向负荷。
High radial load capacity, especially for heavy loads or vibration, but can not afford a pure axial load.
有高的径向载荷能力，特别适用于重载或振动载荷下工作，但不能承受纯轴向载荷。
There are two bi-directional thrust bearing rolling bodies, each listed in only one direction of axial load.
有两列滚动体的双向推力滚动轴承，每列只在一个方向承受轴向负荷。
If the actual load is a combined radial and axial load, then an equivalent static bearing load must be calculated.
如实际负荷为径向和轴向复合负荷，则必须计算当量轴承静负荷。
The results show that increasing the boundary confinement ratio of the walls can raise allowable axial load ratio.
研究结果表明，适当增加约束区约束钢筋的配筋率可以提高剪力墙的轴压比限值。
With this situation, any amount of axial load can be applied to compressive bar of arbitrary length without bending.
在此状态下可在任意长度的压杆上，加任意大小的轴向载荷，而不产生弯曲。
Deep groove ball bearing is inseparable bearing, mainly it can be subject to radial load and some axial load as well.
深沟球轴承属于不可分离型轴承，主要承受径向载荷，也可承受一定量的轴向载荷。
The higher the speed should not adopt thrust ball bearings available class bearings are subjected to purely axial load.
在转速较高不宜采用推力球轴承的情况下可用该类轴承承受纯轴向负荷。
In the range of research, the tubing failure is not strength calculation problem under internal pressure and axial load.
在所研究的范围内，得出了内压和轴力作用下，油管失效不是油管强度不足的结论。
The rule of lateral vibration under axial load was studied in theory, the inherent frequency of drilling string was obtained.
从理论上分析了轴向载荷存在的情况下钻柱横向自由振动的规律，获得了钻柱横向振动固有频率。
Tapered members under the axial load: the stresses formulas of the tapered members and those of the prismatic ones are identical.
轴向荷载作用下：楔形变截面构件的正应力和剪应力公式与等截面构件的正应力公式比较接近。
An experimental study of the nonlinear dynamic response of a clamped sliding buckled beam under a harmonic axial load is presented.
对一端固定、一端滑动、受轴向简谐激励的屈曲梁的非线性动力学行为进行了实验研究。
Besides, the eccentricity magnifying coefficient and the axial load limit for steel reinforced concrete column were also introduced.
文中还介绍了钢骨混凝土柱偏心距增大系数和轴压力限值的计算。
TIMKEN-aligning roller bearings with two rollers, the main path a load to bear, but also can withstand axial load in either direction.
TIMKEN调心滚子轴承具有两列滚子，主要承受径一载荷，同时也能承受任一方向的轴向载荷。
Single-row Angular Contact ball bearings can sustain radial, axial or composite loads, however, any axial load must be in one direction.
单列角接触球轴承可承受径向，轴向或复合负荷，不过，任何轴向负载必须在一个方向。
The axial load and centralizer spacing from the bottom to the top are calculated by using the mechanical analysis method and the log data.
采用力学分析的方法，结合测井资料，由下到上计算了抽油杆柱的扶正器间距和轴向力。
The calibration for the axial load and the stability shows that the axial load assignment is reasonable with higher stability and security.
对轴荷和稳定性校核表明：轴荷分配合理，具有良好的稳定性和安全性。
These bearings have a particularly high axial load carrying capacity and are used primarily as thrust bearings in rolling mill applications.
这些轴承有特别高的轴向负荷能力，主要用作轧钢机里的推力轴承。
Other test parameters include the level of axial load in the CFST column, the load level in the RC beam and the beam-column stiffness ratio.
其他测试参数包括水平轴向载荷作用下的钢管混凝土柱、水平荷载下的钢筋混凝土梁和框架梁柱的刚度比。
These bearings can accommodate a certain proportion of radial load in addition to the axial load (see under "Equivalent dynamic bearing load").
除轴向负荷外，此类轴承还能承受一定的径向负荷（见“当量轴承动负荷”）。
The regression statistical method has been used to analyze the law of stress and strain as The Times under the function of axial load increases.
研究了铺装层应力场分布，回归统计了随轴载作用次数增加，应力应变的变化规律。
The regression statistical method has been used to analyze the law of stress and strain as The Times under the function of axial load increases.
研究了铺装层应力场分布，回归统计了随轴载作用次数增加，应力应变的变化规律。
应用推荐