... bonding strength结合强度；粘接强度；黏合强度 hydrogen bonding氢键；氢键结合 bonding agent粘合剂，结合剂；保税授信机构 ...
基于1个网页-相关网页
... bonding strength结合强度；粘接强度；黏合强度 hydrogen bonding氢键；氢键结合 bonding agent粘合剂，结合剂；保税授信机构 ...
基于1个网页-相关网页
bonding strength of laminated fabric 双层织物的结合强力
surface bonding strength [材] 表面结合强度
specific bonding strength 比结合强度
shear bonding strength 剪切固结强度 ; 剪切状态下的粘合性
Bonding strength at room temperature 常态粘结性
Internal Bonding Strength 内结合强度
Bonding strength with the cement 与水泥粘接强度
Interfacial Bonding Strength 界面粘接强度
tensile bonding strength 的抗张粘接强度 ; 抗张粘接强度
The results show that:the coating hasa unique with Vickers micro-hardness of 1 134HV0.1 and bonding strength more than 64 MPa.
结果表明:该涂层具有独特的显微组织结构;涂层的维氏显微硬度达到了1 134HV0.1;结合强度超过64 MPa。
参考来源 - 高能高速等离子喷涂纳米AlAfter gaining the best activation patterns and the best content of coal gangue in cement mortar,the flexural strength ,compressive strength, bonding strength and consistency of the mortar were tested after adding fibrous brucite and water-reducing agent.
在获得了煤矸石在水泥砂浆中最佳活化方式和最佳掺量后,在原掺煤矸石普通砂浆的基础上掺入水镁石纤维及减水剂进行不同灰矸比和不同灰砂比的水泥砂浆试验,除了抗折抗压强度测试外,还测试了砂浆的粘结强度和稠度。
参考来源 - 煤矸石的活性与应用研究In this paper, a silver-epoxy adhesive die-attachment for experiment was prepared. Various experiment conditions for optimal bonding strength of the die-attachment were investigated by shear-mode experiments.
制备了用于试验研究的银导电胶互联的基板-芯片试样,通过剪切模式破坏试验,研究了为获得银导电胶的最佳粘接强度的各种试验条件。
参考来源 - 银导电胶粘接可靠性研究The main method which judges whether an adhesive system works or not is the bonding strength test.
粘接强度测试是评价一种牙本质粘接系统性能的重要方法。
参考来源 - 不同状态下牙本质对其与树脂粘接强度影响的研究The shear bonding strength showed no significant difference between two groups,which met the clinical requirement.
同时两组牙齿间托槽的抗剪粘结强度没有显著的差异性,且都能满足正畸临床应用中对托槽抗剪粘结强度的要求。
参考来源 - FQ光固化防龋涂料预防粘结托槽牙面脱矿的体外研究—《中国美容医学》—2010年第2期—龙源期刊网Culcination temperature and time influence the self-generated oxide layer, and then act on the coating’s quality and bonding strength.
煅烧温度和时间通过对自生氧化层的作用影响涂层质量和结合强度。
参考来源 - KSo did the 5-ply panels. Bonding tests showed that compressing method could improve 5% of panels’ bonding strength and percentage of wood failure.
剪切实验表明，胶合板的胶合强度和木破率都由于单板的压缩均提高了5％左右。
参考来源 - 加拿大杨木单板的挤压脱水干燥When the temperature is 140°C, the bonding strength is 1.65MPa, which meets to the requirement of I-plywood.
热压温度为140℃时，胶合强度为1.65MPa，达到Ⅰ类胶合板胶合强度要求。
参考来源 - 竹材加工剩余物酚化及其胶粘剂制造技术By modeling, the formulas for calculating the line peel-off intensity and the plane peel-off intensity were deduced, and the standard to estimate the bonding strength was put forward.
最先引入了线剥离强度和面剥离强度两个附着力性能评价参数,通过建模推导出计算公式,从而给出了附着力检测评价标准。
参考来源 - 粉末涂料涂层附着力检测方法与装置研究That defects are mainly in interface of SDB affects bonding strength.
硅键合片的缺陷主要集中在键合界面,键合强度受到很大影响。
参考来源 - 硅硅直接键合的理论及工艺研究·2,447,543篇论文数据，部分数据来源于NoteExpress
The relationship of bonding strength and temperature are investigated.
分析了键合强度与键合温度之间的关系。
The effects of dosage of each material on the bonding strength were studied.
研究了原材料的用量变化对胶粘剂粘接强度的影响。
The influences of ultrasonic power on heavy aluminum wire wedge bonding strength were investigated.
超声功率是影响粗铝丝引线键合强度的最主要因素之一。
应用推荐