Normally the shear velocity is about half of the compressional velocity.
一般地说横波速度大约是纵波速度的一半。
Using the transient Rayleigh wave method can measure the shear velocity of site soil and estimate the bearing capacity of pile.
应用瞬态瑞雷波技术可快速检测桩周土的剪切波速，从而实现单桩承载力的检测。
Finally, the characteristics of shear velocity distribution in the crust and the upper mantle obtained by inversion has been discussed.
讨论了反演所得地壳与上地幔的横波速度分布特征。
The propagation process of the Alfven wave in a shear velocity field is calculated, and the dissipation of Alfven waves in the magnetosphere is given.
计算了剪切流场中阿尔文波的传播过程，以及磁层中阿尔文波的耗散。
In such conditions a shear head wave is generated, so that standard techniques based on monopole transducers can be used to measure formation shear velocity.
在这种情况下会产生横波首波，因此可以使用基于单极子传感器的标准技术测量地层横波。
The gas pool prediction and gas bearing abundance prediction can be carried out through the cross plots of density and bulk modulus with density and shear velocity.
利用密度与体积模量以及密度与横波速度的交会图分析可以进行文西地区气藏预测和含气丰度预测。
The results indicate that the change of membrane resistance is not active when the shear velocity amounts to a certain degree, and membrane resistance will increase…
结果表明，剪切速度达到一定值时膜阻力变化不明显，而随着压力提高膜阻力迅速提高。
Roughness length during the flood phase is larger than that during the ebb phase, whilst shear velocity during the flood phase is smaller than that during the ebb phase.
涨潮阶段床面粗糙长度大于落潮阶段， 涨潮阶段摩阻流速小于落潮阶段。
Shear wave velocity is an important indicator which influence the ability that mediators propagate waves.
剪切波速是反映介质对波传播能力的一个重要指标。
The correlation between cyclic liquefaction resistance of undisturbed and remolded saturated loose silts was studied using the cyclic triaxial apparatus with measurements of shear wave velocity.
采用剪切波速与振动三轴联合试验装置，研究了具有松散结构的原状和重塑饱和粉土抗液化强度之间的相关性。
Through solving the blood flow equations for local vessel expansion region, the analytical expressions of blood flow velocity, pressure and wall shear stress were then obtained.
接着，通过求解局部扩张血管段内的血液流动方程，导得血液流速、压力和血管壁切应力的分析表达式。
The prediction method includes five sequential steps of shear wave velocity estimation, fluid substitution, attribute optimization, attribute classification and reservoir prediction.
该方法操作步骤包括横波速度预测、流体替换、属性优选、属性分类和储层预测等。
The three dimension flow field in the triple-screw extruder with triangle configuration is the research objects, including velocity field, pressure field and shear rate field etc.
本课题以三角形排列的三螺杆挤出机三维流场为研究目标，研究内容包括速度场、压力场、剪切速率场等。
In the range of incident velocities near to the perforation limit velocity (V50), this mechanism depends on thickness and interlaminar shear strength of composite plate.
在接近穿孔极限速度的入射速度(V50)范围内，这一机制依赖于复合材料板的厚度和中间层剪切强度。
Shear wave velocity data measured by these two methods appeared to be good consistency and no obvious frequency dispersion was found from a few hertzs to tens of kilohertzs.
两种方法所测得的剪切波速数据具有很好的一致性，且在数赫兹至数十千赫兹频段范围内剪切波速不具明显弥散性。
Softwares ANSYS and MATLAB were employed to analyze and simulate the velocity, pressure and shear stress distribution in sheet extruder dies based on the three-dimensional FEM.
利用ANSYS和MATLAB软件，对缩放型片材机头中熔体的速度、压力和剪切应力的分布进行三维有限元模拟和分析。
The relation between the gradient of local (plastic) shear deformation and the local (plastic) shear strain and that between the gradient of velocity and the strain rate were established.
建立了局部(塑性)剪切变形梯度与局部(塑性)剪切应变分布之间的关系及速度梯度与应变率分布之间的关系。
The results show that the wavy interface and vortex street are caused by the velocity distribution of shear flow and periodic disturbance at the interface.
研究表明波状界面和涡街是由界面处的剪力流速度分布和周期性扰动所造成的。
Soil shear wave velocity is an important parameter which influence the dynamic properties of soil, and it is widely used in engineering practices.
土层的剪切波速是反映土体动力特性的重要参数。
Melt pumping characteristics, velocity and shear rate distribution profiles of the screw assemblies are analyzed and discussed.
分析并比较了组合螺杆的熔体输送特性、速度场和剪切速率场分布规律。
Based on the working feature of flying shear mechanisms and considering the motion track, velocity and position Angle of connecting rod, a multi-objective optimization model is built.
根据飞剪剪切机构的工作特点，综合考虑连杆运动轨迹、速度和位置角，建立多目标优化模型。
Results as the velocity shear increases to a certain extent, the small scale disturbances will exhibit chaotic behavior, which leads to the production of turbulent spots in local high shear regions.
结果在速度剪切度增大到一定程度时，将会出现小尺度扰动的混沌行为，它导致局部高剪切区中湍斑的产生。
The interrelated model of the shear wave velocity with the normal value of ultimate lateral resistance(qsik)and ultimate end bearing resistance(qpk)of the soil around the pile is established.
建立了桩周土的极限侧阻力标准值及极限端阻力标准值与剪切波速度的相关模型。
Secondly, in conditions of non-steady flow, azinuthal velocity and shear stress distribution were deduced according to function approximation method.
在非稳流下，采用函数拟合法，得出流体切向速度随半径变化的表达式及流体所受切向剪切力和分布曲线。
FLAC-3D is adopted to simulate the influence of end constraint on patterns of shear bands, velocity and displacement fields.
采用FLAC - 3d模拟了端面效应对岩石试件剪切带图案、速度场和位移场的影响。
CFD simulation results show that the entrance velocity is about 24% higher than the local flow velocity, resulting into large surface shear force, is consistent with the experimental results.
CFD模拟结果表明，直管试样入口处局部流速比平均流速高约24%，表面剪切力大，与实验结果一致。
The shear wave velocity method is discussed in detail and its results are compared with those obtained by other methods.
重点讨论了剪切波速法，并将该法和其它方法进行了比较。
Based on some previous results, the relationships between critical shear stress. critical velocity and incipient probability have been derived.
根据现有成果，直接导出了起动切应力、起动流速与起动概率之间的关系。
Therefore, the compressive strength difference of lime-soils can only be evaluated based on the shear wave velocity.
因此，只有依据剪切波速才能评价各种条件下石灰改良土强度特性的差异。
Therefore, the compressive strength difference of lime-soils can only be evaluated based on the shear wave velocity.
因此，只有依据剪切波速才能评价各种条件下石灰改良土强度特性的差异。
应用推荐