Below normal outlet temperature of the gas occurrence boiler.
低于正常值的煤气发生炉出口温度。
These factors include outlet temperature, outlet velocity and outlet diameter.
这些因素包括送风温度、送风速度、送风口直径、送风方式等。
Refrigeration, heating up when the outlet when the outlet temperature down, highly efficient.
制冷时出风口向上，制热时出风口向下酒水团购，调温效率大大提高。
Calibrate the mixed water outlet temperature by placing a thermometer in the mixed water stream.
在混合水流内放置温度计，校准混合水出口的温度。
The response of the outlet temperature to the sudden steam increasing is a large inverse response.
某炼厂焦化炉注蒸汽控制系统不能正常运行，注汽量突增造成炉管出口温度大的反向响应。
Increasing the main steam outlet temperature will increases the available enthalpy drop in the turbine.
提高主蒸汽出口的温度会增加蒸汽在汽轮机中的可用焓降。
This valve requires periodic inspection and verification of the outlet temperature by a licensed contractor.
这种阀门需要由得到许可的承包商进行定期检查和确认出水口温度。
Dynamic matrix control system of outlet temperature in constant pressure heating furnace is designed with 2-layer structure.
采用双层控制结构，设计了常压加热炉出口温度的动态矩阵控制系统。
The aero-engine combustion outlet temperature makes a strong impact on the life of engine and the power of the engine output.
航空发动机燃烧室出口温度的高低及出口温度场的均匀程度，直接影响到发动机的工作寿命和输出功率的大小。
With the increase of coal mine methane superficie velocity, pressure loss and outlet temperature of the oxidation bed increase.
随着进入氧化床的乏风气体表观速度的增加，压强损失和出口温度都增加；
Automatic control system of cooler outlet temperature is introduced. It is a core control system in dry dedusting of large converter.
介绍大型转炉干法除尘中的核心控制系统——冷却器出口温度自动控制系统。
The influence of supercritical boiler's hydrodynamic characteristics to the outlet temperature of water wall's lower radiation zone is analyzed.
分析了超临界锅炉水动力特性对下辐射区水冷壁出口温度的影响。
The normal gas outlet temperature of coal gasifier is related to chemical reactivity, volatile matter and moisture content of gasification coal.
发生炉正常炉出煤气温度与气化用煤的化学反应活性和气化用煤的挥发分及水分含量相关。
Meanwhile analysis was made on how primary air, concentration of pulverized coal, mill outlet temperature and pulverized coal fineness affected ion ignition.
为此分析了点火过程中一次风速、煤粉浓度、磨煤机出口温度和煤粉细度等对等离子点火的影响。
Under control of the outlet temperature and the pressures, the increase of feed throughput will cause the decrease of gas, gasoline and coke produced in reaction.
再生器压力、沉降器压力和提升管反应器出口温度均被控制，原料处理量提高后，气体、汽油和焦炭产率均下降。
Results from the experiment show that there exists a maximum coefficient of performance and it depends on the evaporation temperature and outlet temperature of the gas cooler.
实验结果表明，系统运行时的最大制冷(热)系数取决于系统的蒸发温度和气体冷却器出口温度。
When the temperature control knob to set a temperature, hot and cold water mixing valve through proportional control into the outlet, the outlet temperature is always constant.
当温度调节旋钮设定某一温度后，混水阀通过调节进入出水口的冷热水比例，使出水温度始终保持恒定。
Compared with the ordinary header, the experimental results show that staggered perforated plate header greatly improves the distribution of outlet flow and outlet temperature.
通过实验与工业用基本型封头对比，结果表明错排孔板型封头能够明显地改善换热器出口截面流量和温度分布的不均匀性。
In the matter - in - loop simulation experiment of aero - engine control system, the turbine outlet temperature, which characteristics with high and quick change , is hard to be simulated.
航空发动机控制系统半物理模拟试验中，涡轮出口气体温度高、变化快，难以模拟。
The effecting factors of low outlet temperature in melamine dryer have been also analyzed, which ensures the stable and long period operation for the melamine dryer and the melamine plant.
还通过进一步分析其温度低的原因，从而保证了干燥器的正常运行。
Taking the noise elimination of the outlet temperature signal of hydrocracking reactor as an example, the effect of the model parameters of the wave filter for noise elimination was compared.
在分析线性滤波器原理的基础上，建立了化工系统动态信号的最优线性滤波器的数学模型，并以加氢裂化反应器出口温度信号的除噪为例比较了滤波器模型参数对去噪效果的影响。
Through experiments of changing the inlet air flow rate, we can adjust the hot air outlet temperature as high as possible, which helps to reduce the heat loss and improve the collector efficiency.
通过改变集热管进口空气流量来获得尽可能高出口温度的热空气，从而降低热损系数，提高集热效率。
The influence of the working fluid pressure and the structure of ejecting nozzle on the outlet temperature, ejecting coefficient and heating efficiency of the ejecting-mixing heater were analyzed.
对多喷嘴引射混合式加热器的加热性能进行了试验研究，分析了工作流体压力和引射孔结构对引射混合式加热器的出口温度、引射系数以及加热效率的影响。
The model is based on the easy measurable parameters, such as the inlet and outlet temperature of flue gas, the wall temperature of air preheater, and the pressure difference of the air preheater.
该模型只利用进出口烟气温度、空气预热器管壁温度和烟气压降等易测参数来监测积灰情况。
The identification model of the heat outlet temperature is applied in internal model control which achieves the better control effect and supplies a feasible solution for the industrial application.
同时将该方法辨识得到的换热器出口温度模型应用在内模控制方案中，取得了较好的控制效果，为其工业应用提供了可行性方案。
Correctly identify the gas outlet temperature target of different coal will help the operator accurately determine and correctly handle the running condition according to the gas outlet temperature.
正确确定发生炉在气化不同煤种时的正常炉出煤气温度指标，有利于操作人员根据出煤气温度的变化，准确判断并正确处理炉况。
All of the ion exchanger resins are temperature sensitive; therefore, a temperature diver valve bypasses letdown flow if the letdown heat exchanger outlet temperature rises to a predetermined value.
所有的树脂床对温度都有要求，因此当温度超过预定值时，下泄流将旁通净化床运行。
All of the ion exchanger resins are temperature sensitive; therefore, a temperature diver valve bypasses letdown flow if the letdown heat exchanger outlet temperature rises to a predetermined value.
所有的树脂床对温度都有要求，因此当温度超过预定值时，下泄流将旁通净化床运行。
应用推荐