For example, castings, forgings, or bar, shape, size, machining allowance, and so on.
例如铸件、锻件或棒料、形状、尺寸、加工余量等。
Repair machining methods for the high precision taper bore with small machining allowance have been described.
介绍大齿轮高精度圆锥孔小余量进行修复的加工方法。
Computer programs were developed, with which the distribution of finished machining allowance was obviously displayed.
编制了计算机程序，在计算机上可以非常直观地看出精切余量分布情况。
Starting with the constrained optimization method, an algorithm for the even distribution of the machining allowance is developed.
从约束优化方法入手，提出了复杂等距型面加工余量均布优化算法。
The analysis of thermal damage layer for the rake face can provide theoretical guidances for confirming the machining allowance of surface grinding.
前刀面热损伤层的定量分析，可以为随动磨削的加工余量提供理论依据。
The study of thermal damage layer for the major flank can provide theoretical guidances for determining the minimum machining allowance of edge grinding.
后刀面热损伤层的定量分析，可以为确定最小刃磨余量提供理论支持。
By comparing the least distance between subdivided control mesh and limit surface with rough machining allowance, the uniform subdivision depth was determined.
该算法以细分后的控制网格与极限曲面之间的最小距离和粗加工余量作比较，确定均匀细分次数。
The joined moulded parts are subsequently machined to achieve the desired final geometry or a geometry corresponding to the desired final geometry plus the machining allowance.
接着为了达到所期望的最终形状或所期望的含有余量的最终形状使接合的成形件加工成相应的形状。
Boring as far as possible out smaller distances in boring bar clamping, but need to pay attention to the cutting edge length should meet the machining allowance, and is conducive to the chip.
镗刀在镗刀杆上装夹时应尽可能伸出较小的距离，但需要注意切削刃伸出长度应符合加工余量，并有利于排屑。
The paper discusses in detail the principle of selecting the stock of turbine blade and determining the allowance for machining the stock.
详细论述了汽轮机叶片各种毛坯形式的选择原则及毛坯机械加工余量的确定。
Provided that the reasonable welding shrinkage allowance is reserved during the manufacture of steel structure products, the unnecessary machining procedure can be avoided.
钢结构件制造中，预留合理的焊接收缩量，可减少不必要的加工工序。
These results were compared with those achieved using the traditional method of designing the uniform allowance for machining to turbine blade. The results sh…
分析表明，新工艺与传统的余量设计方法相比有诸多优点，为该新工艺的工业化应用奠定了理论基础。
These results were compared with those achieved using the traditional method of designing the uniform allowance for machining to turbine blade. The results sh…
分析表明，新工艺与传统的余量设计方法相比有诸多优点，为该新工艺的工业化应用奠定了理论基础。
应用推荐