For nontransparent plastics, choices are limited to destructive tests such as layer removal, section removal, and stress-corrosion tests.
对于缺乏透明度，塑料，选择是有限的破坏性试验，如层去除，第移除，以及应力腐蚀的考验。
The paper discusses over the influence exerted by welding residual stress on the static strength, brittle fracture and stress-corrosion cracking of metal structure.
本文介绍了焊接残余应力对金属结构的静强度、脆性断裂以及应力腐蚀开裂的影响。
There are reactor coolant system weld issues, they're used and they're getting primary water stress corrosion cracking.
还有反应堆冷却剂系统焊接问题，它们使用了并且得到原生水,应力腐蚀裂痕。
Stress corrosion cracking problem of concrete beams with crack is studied in this paper.
本文研究了带裂纹混凝土梁的应力腐蚀断裂问题。
Stress corrosion cracking in which the cracking occurs along grain boundaries.
沿着晶界发生的应力腐蚀开裂。
The pit then grows through the compressive layer, and the change in residual stress state and the pit geometry initiate stress corrosion cracking.
随后斑点穿过压缩层继续扩展，剩余应力发生改变，斑点最终导致应力腐蚀裂纹。
Stress corrosion cracking of an X60 pipeline steel in soil containing water has been investigated using slow strain rate test.
用光滑试样慢应变速率拉伸法研究了X60管线钢在含水土壤中的应力腐蚀。
Through-thickness cracking also can lead to fatigue or stress corrosion cracking of the base metal beneath the plating.
还会形成穿透型裂纹，造成镀层下本体金属的疲劳或应力腐蚀裂纹。
The influencing factors on the durableness of anchor with stress corrosion by the way of simulation in laboratory and site sampling are studied.
通过室内模拟试验和现场取样测试的方式，对比研究应力腐蚀条件下影响锚杆使用寿命的因素。
The role of hydrogen embrittlement in stress corrosion cracking has also been discussed.
文中还对氢脆在应力腐蚀开裂中的作用进行了讨论。
Through the discussion on the mechanism and effect factors of the stress corrosion cracking by sulfides, this paper expounds its harmfulness and proposes some measures to control it.
本文通过对硫化物应力腐蚀开裂的机理和影响因素的讨论，说明其危害性并提出了控制方法。
The stress corrosion mechanism in mixed solutions was studied based on the metallographic observations of scanning fracture shapes and crack extension direction.
根据扫描断口形貌和裂纹扩展途径的金相观察，还探讨了在混合溶液中的应力腐蚀机制。
It has been proved that these cracks are caused by sulfide stress corrosion cracking (SSCC) through failure analysis and service environment survey.
通过失效分析和管道服役环境调查，证明开裂原因是管道服役期间发生硫化物应力腐蚀开裂(SSCC)。
The results show that the failure of the tube is due to stress corrosion crack propagation.
结果表明，该进气管断裂系由于应力腐蚀裂纹失稳扩展所造成。
After the integrated analysis of each test result, it is proved that the pipe leakage failure is of stress corrosion damage.
在对各项试验结果进行综合分析之后确认，该管路泄漏失效为应力腐蚀破坏。
The heat treatment process of 7005 alloy is studied in terms of mechanical properties and resistance to stress corrosion test.
通过力学性能以及抗应力腐蚀的测定，对7005铝合金的热处理工艺进行了研究。
The stress corrosion cracking of metastable austenitic stainless steel has been investigated.
研究了亚稳态奥氏体不锈钢的应力腐蚀开裂。
The results show that the cracking of the pipe is a kind of stress corrosion cracking.
分析结果表明，高压油管的开裂是应力腐蚀开裂造成的。
The presence of the greater residual tensile stress induces the stress corrosion cracking in the course of the acid pickling.
其原因是磁屏表面存在较大的切向拉应力，从而在酸洗过程中产生了应力腐蚀开裂。
The study of stress corrosion testing.
应力腐蚀试验研究。
The stress corrosion cracking(SCC) of carbon steels in aqueous alkali was studied by electrochemical technique, stress corrosion test under constant load and repassivation test.
本工作通过电化学，恒载荷应力腐蚀和再钝化试验，对碳钢在碱溶液中的应力腐蚀破裂进行了研究。
This paper mainly introduces the stainless steel corrosion, especially the serious accidents caused by the austenitic stainless steel stress corrosion crack.
论文主要介绍了不锈钢的腐蚀尤其对奥氏体不锈钢的应力腐蚀开裂引起的严重事故。
Simulated galvanic cell tests and stress corrosion tests using pre-creeping specimens were conducted.
进行了模拟原电池试验和预蠕变试样的应力腐蚀试验。
The failure of the hollow cylinder roller bearing is stress corrosion wearing.
空心圆柱滚子轴承为应力腐蚀磨损失效。
Pitting corrosion and crevice corrosion in catalyst deposit zone and corrosion deposit zone can also induce stress corrosion cracking.
催化剂沉积区和腐蚀产物沉积区产生的点蚀和缝隙腐蚀会诱发应力腐蚀开裂的产生。
Stress relief treatment is necessary to prevent stress corrosion.
为了防止应力腐蚀需要进行除应力处理。
This article introduced briefly the analysed method of stress corrosion crack, main factors which caused stress corrosion crack and its preventing method.
简要介绍了应力腐蚀开裂的分析方法、引起压力容器应力腐蚀开裂的主要因素及防止措施。
Corrosion reasons of brine preheater were analysed, including brine corrosion, stress corrosion, stray current corrosion and thermocell corrosion.
分析了盐水预热器腐蚀的原因，包括盐水腐蚀、应力腐蚀、杂散电流腐蚀和温差电池腐蚀。
The results show that stress corrosion and corrosion fatigue are the main causes for the fracture failure.
结果表明，断裂失效的原因主要是应力腐蚀和腐蚀疲劳。
The results show that stress corrosion and corrosion fatigue are the main causes for the fracture failure.
结果表明，断裂失效的原因主要是应力腐蚀和腐蚀疲劳。
应用推荐