From the pump shaft to watch out for clockwise.
从主轴外伸端向泵看，为顺时针旋转。
The pump shaft is engaged and turned by a servo motor.
泵轴由伺服电机控制其转动。
Turn the pump shaft by hand to see if it turns flexibly.
用手转动泵轴检查其是否活络。
Rotating pump shaft by hands, sure to guarantee easy to rotate.
用手转动泵轴，必须保证运转灵活。
Shaft Column: Flanged, heavy wrought steel pipe encases the pump shaft.
立柱：装有法兰，重型锻钢管包围泵轴。
Through a rigid sleeve coupling, pump shaft was connected to the motor shaft.
通过一个刚性套筒联轴器，泵轴被连接至电机轴上。
Inspection of the pump shaft seal ring, such as wear parts should be replaced.
检查水泵轴的油封环，如磨损严重应更换新件。
Suggestion: pump shaft or protective set of surface hardness to achieve 60hrc.
建议：泵轴或防护套的表面硬度要达到60hrc。
And then removed the pump shaft shell removed send impeller repair shop repair.
然后将轴拆出泵壳，拆下叶轮送修理厂修理。
PEP - II of the gear pump shaft, and the body USES hardening craft, can obtain more long working life.
PEP-II泵的齿轮与轴共为一体，采用通体淬硬工艺，可获得更长的工作寿命。
The straightening of the pump shaft is difficult because the bending points on the shaft are hard to determine.
泵轴校直困难，原因是泵轴弯点难以确定。
A lubricating oil pump shaft and a CAM transmission shaft are respectively sheathed in series in two inner cavities.
两内腔内分别串套机油泵轴和凸轮传动轴。
Is clear from the viscosity of the fluid delivery when the pump is not the same time, the pump shaft power will be different.
由上可见，当泵运送的液体粘度不同时，泵的轴功率也将不同。
By visible, when the pump transporting liquid viscosity is not at the same time, the pump shaft power will also be different.
由上可见，当泵运送的液体粘度不同时，泵的轴功率也将不同。
Pump shaft seals use mechanical seal, pump top and bottom, respectively, equipped with water injection plug and the drain plug.
泵的轴封采用机械密封，泵体顶部和底部分别装有注水、放泄的螺塞。
The engine fan is usually mounted on the water pump shaft and is driven by the same belt that drives the pump and the generator.
发动机风扇通常安装在水泵轴上，由驱动水泵和发电机的同一条皮带驱动。
When applicable, pumps shall be designed to allow for the addition of parallel pump units to be coupled by the primary pump shaft.
如合适，应将泵设计成允许加入与主泵轴相连的平行泵单元。？
However, when the pump reaches higher speeds the cracks expand due to centrifugal force and the vane slips on the water pump shaft.
但是，如果水阀滑动较快，裂纹由于离心力会变宽，泵片会从水阀主轴上脱落。
Basic structure of the centrifugal pump is composed of six parts, namely: impeller, pump, pump shaft, bearing, seal ring, stuffing box.
离心泵的基本构造是由六部分组成的，分别是：叶轮，泵体，泵轴，轴承，密封环，填料函。
Shaft: The pump shaft is made of a high grade stainless steel, ground and polished, and is of a large diameter designed for high torque.
传动轴：泵传动轴是由高等级不锈钢制成，平整光滑，直径大，适用于扭矩大的情况。
The fracture of the pump shaft is mainly caused by large size non metallic inclusions and point welding between the lock nut and the pump shaft.
结果表明，大尺寸的非金属夹杂和背帽外缘的点焊是引起泵轴过早断裂的主要原因。
The fan is usually mounted on an extension of the water pump shaft and is driven by V-belt from a pulley mounted on the front end of the cramshaft.
风扇常常装在水泵轴的伸出物上，由安装在曲轴前段的滑轮上的v带驱动。
The rollers are installed on a roller shelf which is connected with a pump shaft, and the pump shaft is homocentric with the inner rim of a pump body.
其滚轮是装在与泵轴联接的滚轮架上，泵轴和泵体的内缘是同心的。
The utility model has the advantages of simple structure, strong practicability, which is suitable for various types of the suspending arm pump shaft.
本实用新型结构简单，实用性强，可适用于各种悬臂泵轴。
After assembly, move the pump shaft with hand, it should be smooth and uniform without touch. Disassembly can be made with the steps contrary to above ones.
装配完成后，用手转动泵轴，没有擦碰现象，转动比较轻滑均匀即可，拆卸可按上述装配顺序相反的进行。
Sure to rotate the pump shaft when pouring lubricating grease, in order that the grease can get into packing cavity fully until have grease oozed out from gland.
注入润滑脂时必须旋转泵轴，以使其充分进入填料腔，直到填料压盖端有油脂渗出为止。
Pump shaft seal is designed to end in two forms, one for the mechanical seal, one is packing seal, may be based on specific usage and user requirements to determine.
泵轴端密封设计为两种形式，一种为机械密封，一种是填料密封，可根据具体使用情况和用户要求确定。
The centrifugal chemical pump can achieve reasonable pressure and flow rate, ensure low energy consumption and effectively prevent the pump shaft from being corroded.
该离心化工水泵能达到合理的压力和流量、能耗小、有效保护泵轴不被腐蚀。
The centrifugal chemical pump can achieve reasonable pressure and flow rate, ensure low energy consumption and effectively prevent the pump shaft from being corroded.
该离心化工水泵能达到合理的压力和流量、能耗小、有效保护泵轴不被腐蚀。
应用推荐