In higher strain-rate condition, LY12 alloy has good superplasticity and room temperature properties.
在高应变速率条件下,LY 12铝合金具有较好的超塑性和室温性能。
A century ago, 50 million died — a mortality rate far, far higher than this current strain has seen so far.
一个世纪以前,5千万人死于流感——死亡率大大高于迄今为止的猪流感。
The coarse crystalline LC4 alloy exhibit some superplasticity under lower temperature and higher strain rate, because it can create effective recrystallization refinement.
粗晶lc 4合金在较低温度和较高应变速率条件下,因能产生有效的再结晶细化,而呈现出一定的超塑性。
Coarse crystalline LC4 Aluminium Alloy presents certain superplasticity at lower deformation temperature and higher strain rate because it can create effective recrystallize refinement.
粗晶lc 4合金在较低温度和较高应变速率条件下,因能产生有效的再结晶细化而呈现出一定的超塑性。
Comparatively, the slow strain rate method has higher sensitivity.
相比而言,慢应变速率法具有更高的灵敏性。
The higher initial strain hardening rate and higher strength of dual phase are attributed to rapid strain hardening in ferrite and the load transfer from the ferrite to martensite.
铁素体迅速应变硬化和铁素体到马氏体的载荷传递使双相钢具有较高的初始应变硬化速率和较高的强度。
Experimental results proved that GIFT was a strain of Nile tilapia with a higher catching rate.
试验结果证明吉富品系尼罗罗非鱼的起捕率较高。
The strain rate sensitivity of concrete tends to decrease with higher lateral confined stress.
在较高的恒定侧向压力下,混凝土材料对应变速率的敏感程度降低;
In the case of the reverse transformation, the higher the strain rate, the larger the decrease in temperature, resulting in decrease in the transformation stress.
对于逆向转变,高应变率,较大的降低温度,从而减少了转型的压力。
With the temperature rising, the stability of retained austenite gets higher and strain rate also can restrain the transformation of retained austenite.
试验温度越高,残余奥氏体稳定性越好,动态拉伸的绝热效应也抑制了残余奥氏体的形变诱发相变。
At higher strain rate, the alloy exhibits linear-like pseudoelasticity, which is up to 4.5%.
在较高加载速率下,合金表现出类线性超弹性变形行为,可获得高达4.5%的类线性超弹性。
The results show that the higher strain rate leads to a larger crystallinity.
发现在同一应变,越高的应变速率下,橡胶的结晶度也越大。
The flow stress decreased as deformation temperature increased and became higher as strain rate rises.
在含硼中碳钢的热压缩变形过程中,应变速率一定时,随着变形温度的升高,真应力下降;
The results indicate that the efficient strain and strain rate are higher by about 40% than in the center of deformed samples, but are about 1/5~1/4 of set values at the end surface;
结果表明,热压缩变形试样心部的等效应变与应变速率比设定值大40%左右,而端面值则为设定值的1/5~1/4;
The systolic maximum velocity and strain rate of soft plaque in carotid atherosclerosis were higher significantly than those of hard plaque(P<0.001, P<0.05).
软斑块收缩期最大运动速度、最大应变率高于硬斑块组,差异有统计学意义(P<0.001或P<0.05);
The systolic maximum velocity and strain rate of soft plaque in carotid atherosclerosis were higher significantly than those of hard plaque(P<0.001, P<0.05).
软斑块收缩期最大运动速度、最大应变率高于硬斑块组,差异有统计学意义(P<0.001或P<0.05);
应用推荐