They should be clean, dry, and have no cuts. They should be kept in a cool, dry place.
它们须干净,干燥,没有损伤,而且应贮存在阴凉干燥的地方。
Not when placed in dry, clean, no corrosive gas environment.
不用时请放置在干燥、清洁、没有腐蚀性气体的环境中。
Clean on mesa mirror: will the glass on the glass, detergent spray with dishcloth, finally clean with dry cloth rub-up, make the light, no stains.
清洁台面上的镜面:将玻璃洗涤剂喷洒在玻璃上,在用抹布擦拭干净,最后用干布擦净,使其发光,无污迹。
The device should be placed in the environment with dry, clean, dust-proof, no corrosive gas, no strong electromagnetic interference.
仪器应该安放在干燥、清洁、防尘、无腐蚀气体、无强电磁场干扰的环境中。
Before painting, interior cement wall and ceiling surfaces must be firm, flat, dry, clean and no dust, should be noted.
涂装前,室内水泥墙面及天花板表面必须稳固、平整、干燥、清洁和无浮尘,应注意。
Sticking surface should be clean, smooth, dry, no fat or other pollutant.
被粘物表面应清洁干净、平滑、干燥、无油脂或其它污染物。
Clean sand requirement, there should be no sawdust, stones and other sundry, particle size between 1 ~ 2 mm, Fried dry before use.
砂粒要求洁净,不应有木屑、石块等杂物,粒径在1 ~2毫米之间,使用前要炒干。
Dry after clean, and cover the places where no need to spray, including tailpipe, engine, water tank, spring and frame number.
清洁后必须用风吹干,再将不需要的喷的地方用纸严密封盖(包括排气管、发动机、水箱、弹簧、车架号码等)。
Substrate surface must be clean dry and no oil.
将要施涂的表面必须完全干净、干燥及无油脂。
Please wash separately, hand wash or dry clean only, no machine wash.
请分开分色洗涤,只可用手轻轻搓洗或干洗,不可使用机洗;
To clean, make a mixture of water and mild, natural soap (no detergents). Use a soft bristle brush to clean, allowing the soap to soak in. Rinse thoroughly and air dry.
使用温和型肥皂水(液体洗涤剂)简单清洗表面,使用软毛刷,允许肥皂水浸湿,最后清水冲洗干净和风干即可。
For long time no use, clean the appliance and store it after dry.
长时间不用时,请将电锅清洁干净,待其干燥后收藏。
1 to 2 hours until relief is no longer wet dry. Will relief washed clean with clear water. With an old towel dry.
风干1至2小时直到浮雕不再湿。用清水将浮雕冲刷洁净。用旧毛巾擦干。
1 to 2 hours until relief is no longer wet dry. Will relief washed clean with clear water. With an old towel dry.
风干1至2小时直到浮雕不再湿。用清水将浮雕冲刷洁净。用旧毛巾擦干。
应用推荐