Reciprocating pump discharge pipe must be before the start of the valve to open.
往复泵启动前必须将排出管路中的阀门打开。
Press out the liquid at this time to overcome the pressure out of pipeline systems with all the necessary resistance to the pressure from the pump discharge.
压出,此时液体带有克服压出管道系统所有阻力所必需的压力从泵中排出。
The pump casing shall be suitably ribbed have tangential discharge and be reinforced to support the weight of the motor assembly.
泵壳应该有适当的肋骨,按切线方向排放,能够再加固以支撑电机总成的重量。
The pump casing shall be suitably ribbed, have tangential discharge, and be reinforced to support the weight of the motor assembly.
泵壳应该有适当的肋骨,按切线方向排放,能够再加固以支撑电机总成的重量。
Do not let pump run for long in the circumstance of discharge valve closed.
注意不要在排出阀关闭的状态下长期运转。
The pump casing shall be suitably ribbed have tangent ial discharge and be reinforced to support the weight of the motor assembly.
泵壳应该有适当的肋骨,按切线方向排放,能够再加固以支撑电机总成的重量。
The discharge elbow shall be designed to carry the full weight of the pump, motor and discharge piping.
排泄弯头设计结构应该能够承受泵、电机和排泄管道的全部压力。
The whole test stand is mainly made of pump stage part, intake part, discharge part and data acquisition part.
整个试验台架由泵级部分、吸入部分、排出部分和数据采集部分组成。
The level of suction pumps for the axial direction, pump discharge outlet may be fitted into the needed horizontal or vertical direction.
泵吸入口为轴向水平方向,泵排出口可根据需要装成水平或垂直方向。
This set of components can rotate to the back leakage discharge hole and pump the bottom of the alignment.
这样可以使整套部件旋转至背板漏液排出孔与泵的最底端对齐。
The addendum coefficient is an important parameter in the designing the gear, and to affect the discharge characteristic of compound gear pump.
齿顶高系数是设计齿轮时的重要几何参数,也是影响复合齿轮泵流量特性的重要参数之一。
The side of a pump where the suction and discharge valves, pump cylinders, liners, and rods are located.
泵的置有吸入阀和排出阀、泵缸、缸套和拉杆的一侧。
Theoretically the sum of the velocities of the three pistons on the discharge stroke in a low-fluctuation triplex pump should be a constant, and this can be achieved by means of the cam mechanism.
对于三缸低波动往复泵,理论上应使三个活塞在排出行程(吸入行程)中的速度之和为一常数,采用凸轮机构能达到这一目的。
The rotary motion of a profiled impeller in combination with a shaped pump housing or volute applies centrifugal force to discharge fluids from the pump.
成型叶轮的旋转运动以及成型的泵壳或蜗壳产生离心力从泵中排出流体。
Typically, the unloader is mounted directly on the discharge side of the pump.
特别是减压器是直接安装在泵边上的。
In order to reduce the fluctuation of pressure and discharge capacity of the triplex drilling pump, the air accumulator is often fixed on the discharge pipe.
为了降低三缸单作用钻井泵的压力和排量波动,通常在排出管线上安装有空气包。
Sludge pump for discharge of sludge, but also with a larger particle size in the discharge of solid water.
污泥泵适于排放污泥,也适用于排放含较大粒径固体的水。
TUPWR algorithm was adopted for the pump turbine model, SFPUMP for feed pump system, SOVLV for minimal flow valve, and pressure node for calculating the discharge rate of the pump.
给水泵汽轮机模型采用TUPWR算法,给水泵系统采用SFPUMP算法,最小流量阀采用SOVLV算法,泵出口流量的关系采用压力节点进行计算。
This pump is of horizontal single stage and single suction type with radial split, axial suction and radial discharge. It is fully enclosed and leakage free.
该型泵为单级、单吸、卧式、径向剖分,轴向吸入、径向排出。全密封,无泄漏。
The differential equation of pump station start-up transient is established and derived from discharge balance and moment equation of pump unit.
本文从水量平衡及水泵机组力矩方程出发,建立起水泵从起动到同步的微分方程序。
This paper introduces the structure and hydraulic design of the multiphase flow centrifugal pump, which draught sands from the riverbed and discharge the air of the suction pipe.
文章介绍一种用于从河底吸取泥砂并且有自吸排气的离心式多相流泵的结构及水力设计。
The pump features a variable discharge port design which adjusts automatically to the internal compression ratio of the vacuum pump resulting in maximum efficiency throughout the vacuum range.
我们公司生产的液环真空泵,具有不同的出料口,自动调节内部压缩率,已达到最大的真空效率。
When the pump is first started, rotation of gears forces air out the casing and into the discharge pipe.
当泵首次启动时,齿轮的旋转迫使空气离开壳体进入排油管。
If the ground-source heat pump are used in open systems, namely the use of direct extraction of groundwater and pumps refrigerant for heat exchange, and at suitable locations recharge or discharge.
如果地源热泵采用的是开路系统,即利用水泵直接抽取地下水与制冷剂进行热交换,并在合适地点回灌或排放。
Pump valve spring fracture is another common typical fault of emulsion pump with high pressure and large discharge which reduces the volumetric efficiency of emulsion pump greatly.
泵阀弹簧断裂是高压大流量乳化液泵的另一种常见典型故障,极大地影响了乳化液泵的容积效率。
Imersion oil electric pump unit is a kind of oil jack with rodless deep extraction, large discharge capacity and high lift.
潜油电泵机组是一种无杆深抽、排量大、扬程高的抽油设备。
The result showed that the pump has the advantages of larger discharge and smaller pulsation.
结果表明,该泵具有排量大、脉动小等优点。
The results are significant for decreasing hydraulic loss of discharge passage, pump assembly optimum design and increasing pump assembly efficiency.
成果对减小出水流道水力损失,实现泵装置优化设计,提高泵装置效率有重大意义。
About the calculation on the discharge head provided to gas by pump, the paper presents three kinds of calculation methods, analyzes and compares the case calculation results.
在计算泵提供给气体的扬程时给出了三种算法,并对实例计算结果进行了分析比较。
Strong self-suction pump is a kind of mechanical self-suction pump with unique vacuum unit. It can discharge completely air of suction side making running conditions for the pump.
强自吸泵为机械式自吸泵,具有独特的吸真空装置,可将泵的吸入侧空气排净,达到泵正常运转的条件。
应用推荐