The content of this research is as follows: Direct modeling for tooth surface of ti worm in ANSYS is difficult for the equations of contact lines being a kind of transcendental function.
主要研究内容如下：由于TI蜗杆齿面上的接触线方程是一种超越函数，直接在有限元分析软件ANSYS中建模比较困难。
Because of the tooth thickness of the dedendum is larger than that of the common involute gear and the Pitchs do not contact each other, the beam strength and surface strength of tooth are increased.
由于该齿轮的齿根厚度比普通渐开线齿轮的齿根厚，并且节点附近不相接触，因此，其轮齿弯曲强度和接触强度都提高。
Due to the above mentioned defects, early fatigue peeling occurs under the condition of overly contact stress at the top of the tooth caused by abnormal contact at the tooth surface.
因此，在齿面非正常接触导致齿顶接触应力过大的情况下，该齿轮发生了早期疲劳剥落。
The algorithm of disperse tooth surface contact analysis is established and deduced, which lays the foundation for the digital measure and analyzing of tooth surface.
建立和推导了离散齿面接触分析算法，为齿面数字化测量分析提供基础。
Factors influencing the tooth bulk temperature and the surface transient contact temperature of involute gears with standard and modified tooth profiles are investigated.
分析了标准和齿顶修形渐开线齿轮的轮齿本体温度和瞬时接触温度及相关因素对它们的影响。
Differing from previous studies, the new method was derived from the idea of motion of moving trihedron along a predesigned path of contact on the predesigned (theoretical) tooth surface.
与以往的齿面加工方法不同，在新的齿面展成方法中，齿面展成运动是在沿预定接触迹线的曲面活动标架下设计的。
Equations for describing the tooth surface of a face-gear were established, and the contact path was formed by differential geometry and meshing theory.
推导了双圆环面包络环面蜗杆磨齿啮合界线方程及其与相配蜗轮啮合的啮合界线方程。
Equations for describing the tooth surface of a face-gear were established, and the contact path was formed by differential geometry and meshing theory.
推导了双圆环面包络环面蜗杆磨齿啮合界线方程及其与相配蜗轮啮合的啮合界线方程。
应用推荐