• The influence of the variable ratio on the slip and contact stress is also discovered.

    揭示了速比变化比值齿滑移齿接触应力特性影响

    dict.cnki.net

  • According to the calculation results, the fatigue life of gears is calculated by limited life design theory and the contact stress and fatigue life are obtained.

    根据计算结果,应用齿轮有限寿命设计理论齿轮疲劳寿命进行计算得到齿轮接触应力疲劳寿命

    www.dictall.com

  • In this paper, the calculating method for the contact stress of plate CAM mechanism with translating roller moving follower is presented, and some examples are given.

    本文详细分析对心滚子移动从动件形凸轮机构接触应力计算方法给出具体计算例题

    dict.cnki.net

  • The elasticity module of ADI is lower than that of steels, so that the surface contact stress borne by ADI gears during working process would be lower than steels.

    材料弹性因而齿轮工作受到表面接触应力齿轮

    dict.cnki.net

  • The formulae of contact stress and sliding velocity of solid-lubricated ball bearings are deduced by Hertzian contact theory and kinematics of ball bearing.

    根据赫兹接触理论运动学基本原理,推导了固体润滑轴承接触应力滑动速度公式

    www.dictall.com

  • The contact stress is reduced, the life of the wheel, roller and bearings is prolong, it makes autocontrol easy and increases rotate speed of kiln.

    降低接触应力提高轮带、托轴承寿命便于实现自动控制提高转速

    dict.cnki.net

  • This article presents an analysis of the contact stress of rolls in two-cross-roll straightener and gives a method for the calculation.

    实践基础上矫直接触应力计算进行了理论分析给出了接触应力计算方法

    www.ilib.cn

  • Due to the above mentioned defects, early fatigue peeling occurs under the condition of overly contact stress at the top of the tooth caused by abnormal contact at the tooth surface.

    因此齿非正常接触导致齿接触应力过大情况下,该齿轮发生早期疲劳剥落

    en.zidian8.com

  • Via analysis of different plate thickness combinations of equality height spacer plate group, contact stress curves and contact area distribution among the plates were got.

    整体高度恒定垫板不同组合进行分析得到不同组合时各层垫板接触应力曲线统计了各个接触接触面积

    www.dictall.com

  • In the mean time, rolling contact stress, braking heat energy, thermal crack and mechanical action are key causes of tread spalling.

    其中滚动接触剥离制动剥离两种主要剥离类型,滚动接触应力制动作用裂纹机械作用引起剥离主要原因

    dict.cnki.net

  • Abstr: In the process of rolling, roll and rolling contact stress between metal material is larger, and periodic stress and strain.

    文章摘要轧制过程轧辊轧制金属材料之间接触应力较大承受周期性应力应变

    www.redlib.cn

  • The results showed that the major cause of thread gluing is over plastic deformation of partial thread face, and that the distribution of contact stress can be improved with the taper mutation, wh...

    认为产生主要原因螺纹齿局部过量塑性变形,通过变锥度方式使接触应力分布规律得到改善在现场生产中得到验证。

    www.chemyq.com

  • The contact fatigue tester has high contact stress, small volume, low noise, low consumption of test sam-pl, stable driving system and reliable results.

    认为装置具有接触应力大体积噪声,一次试验耗油量试验系统传动稳定试验结果可信等优点

    dict.cnki.net

  • In this paper, an electric device is proposed to measure contact stress on the sealing surface of sealing elements.

    介绍了西北工业大学研制密封面接触应力装置

    dict.cnki.net

  • But in the textbook about CAM, the contact stress calculating process is seldom discussed.

    有关凸轮教科书中接触应力计算过程论述较少

    dict.cnki.net

  • And the influences of gear parameters and friction on the contact stress have also been evaluated.

    通过计算定量分析了各齿轮参数齿摩擦接触应力影响

    dict.cnki.net

  • The distribution of the contact stress of FG is obtained in the different meshing locations during the meshing.

    获得了啮合过程不同啮合位置齿轮接触应力分布规律

    dict.cnki.net

  • An inverse stochastic boundary element method for prediction of contact stress is presented by combining improved filter algorithm with stochastic boundary element method.

    改进滤波算法随机边界结合提出了用于预测接触应力随机边界

    dict.cnki.net

  • The influence of pneumatic pressure, sealed pressure and axial diameter on normal contact stress was discussed.

    讨论充气压力密封压力充气压力比、轴径对法向接触应力影响

    dict.cnki.net

  • This paper primarily represents the study and discussion about computing methods and modeling of load share of contact stress and bending stress of static mesh and dynamic mesh of DCAHG.

    本文主要双圆弧齿轮传动载荷分配啮合啮合接触弯曲应力分析模型计算方法研究探讨

    dict.cnki.net

  • The contact stress distribution in the rabbet of the aircraft engine blade was determined by combining the experimental and numerical methods.

    文中将实验检测技术数值计算方法相结合求解飞机发动机叶片榫头接触应力分布

    dict.cnki.net

  • After calculating with finite element method and photoelastic-test, it shows that the contact stress distribution is not in keeping with the formulas given by some bearing hand books and textbooks.

    通过有限元计算弹性实验,结果证明,滚针轴承接触应力分布轴承手册教科书给出公式不符。

    dict.cnki.net

  • Based on the theory analysis of the equal contact stress inner curve, the experiment research is discussed, and the project of experiment is also designed.

    理论分析接触应力轨道曲线基础试验研究进行了探讨设计了相应试验方案

    dict.cnki.net

  • The elastic theoretical solution of the contact stress between concrete and rock on the abutment of arch is proposed using simplified calculation in this paper.

    本文简化计算得到座处混凝土拱坝岩基接触应力弹性理论表达式;

    dict.cnki.net

  • Thirdly, the contact stress equations of asymmetric gear with two pressure angles are derived by the Hertz theory of classical contact mechanics.

    再次根据经典接触力学中的赫兹理论推导了双压力对称齿轮齿接触应力计算公式

    dict.cnki.net

  • The remarkable changes of contact stress of patellofemoral joint, the cartilaginous degeneration, and matrix proteoglycan loss not found in the lateral cartilaginous side of patella.

    髌骨侧面软骨接触压力明显改变软骨变性明显,蛋白多糖含量无明显减少

    dict.cnki.net

  • The definition of rated static torque for linear rolling guide is given according to the criterion for maximum contact stress.

    基于最大接触应力判据提出滚动直线导轨额定力矩基本定义计算了几种产品额定力矩

    www.dictall.com

  • The definition of rated static torque for linear rolling guide is given according to the criterion for maximum contact stress.

    基于最大接触应力判据提出滚动直线导轨额定力矩基本定义计算了几种产品额定力矩

    www.dictall.com

$firstVoiceSent
- 来自原声例句
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定
小调查
请问您想要如何调整此模块?

感谢您的反馈,我们会尽快进行适当修改!
进来说说原因吧 确定